Mike,
According to their website, N1MM+ does not support the Paragon.
For the others, look here:
<
https://n1mmwp.hamdocs.com/manual-supported/supported-radios/#general-tentec
-information>
73, Ted W4NZ
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Mike Golini
Sent: Tuesday, August 20, 2019 2:16 PM
To: tentec@contesting.com
Subject: [TenTec] N1MM use?
Has anyone used N1MM with their Paragon or Omni V, VI, or VI+?
I have tried it on my Paragon II, but I get a cyclical noise over the
audio (not present when I transmit) using RS232 from my laptop to the radio.
Currently using as a Icom 735 in the N1MM setup (as suggested from the
Operator's Manual). I did try using it as a Omin 6, which did not change
anything.
Just wondering if others have had this problem. Not a show stopper, but
annoying.
73
Mike, K1SLT
--
mgolini@gmail.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|