Yo can get an SDRplay for $120 and use my N4PY Software. I have a one
wire mod to the Jupiter so you can safely share antennas between the
Jupiter and SDRplay.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 8/28/2019 1:34 PM, dale via TenTec wrote:
Picked up a very nice jupiter a while back, great cw rig. anyway I have run
flexradio gear for a number of years and have really gotten used to the
panadaptor. Is there a way I can add a panadaptor to the Ten Tec jupiter?
Would like to do this without getting deeply involved in software etc.Is there
a simple way to get this done with the right software and one of those dusk to
dawn little receivers? I found one article about using a flex 1500 and n4py
software etc, but it was written years before all this new cheap gear was
around.
A poke in the right direction would be great, keep it simple ,my 78 year
old brain absorbs slowly.
73
dale
wt4t
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|