Hi Dennis
It is undoubtedly the battery that needs replacing. I had a friend's 566 to
sort out and that did exactly the same but was fixed when I replaced the
battery.
Go to the Ten Tec Wiki, then to the 565 (not the 566) and that section has
full info on the battery and how to replace it with colour pictures. It
applies to the 566 as well as the 565.
73
Barry Simpson VK2BJ
On Sun, 26 Apr 2020 at 20:30, Dennis OConnor via TenTec <
tentec@contesting.com> wrote:
> Extremely low hours O-II. Sat in a cabinet the past 10 years. (Lower than
> you can imagine.) When first powered up it did a master reset - which I
> noticed but did not think anything of. It continues to reset when turned
> iff and back on. I suspect there is a memory battery somewhere that needs
> replacing. No mention of it in the manual (that I can see) I popped the
> top and bottom covers (never off before) and did a diligent search of the
> nooks and crannies without finding one. Works perfectly otherwise. Any
> suggestions?If you want to reply directly, use AD4HK2004 at
> yahoo.denny/doc K8DO
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|