I have for sale a Ten-Tec Omni VI:
Logic board ROM option 1
DSP Rom Option 1
Front panel buttons have been replaced, no stickers on buttons
All four 6.3 MHz filters from Tentec
9 MHz Filter is Inrad #753-3 (400 Hz / 9000.6 kHz CW 8-pole crystal filter)
Inrad Roofing filter #765 (Omni VI Roofing Filter Mod - CW Low pitch)
The Omni was completely aligned 2018, all works. Photos on request. Asking 450
EUR plus shipment. Ideally the item would be picked up in Munich. Paris /
Toulon also an option.
Please reply off reflector, email on qrz.com is good.
73 de Gerd DF9TS
> On 2. Oct 2020, at 06:35, Malcolm McLeman <f5vbu@cegetel.net> wrote:
>
> I'd snap that up if I lived in the US... GL/73 Malc F5VBU/GM3UIN
> I
> On 10/2/2020 2:17 AM, David Perrin wrote:
>> I have for sale or swap my Ten-Tec Omni VI+ option 3. The “VI+ option 3”
>> was the most expensive of the T-T three update levels and provided the most
>> filtering available. All four crystal filter positions are filled along with
>> the narrow RF filter. It has a built in keyer, runs 100 Watts key down or
>> more. (Doesn’t need a fan). Everything works. Comes with a Ten-Tec 705 desk
>> mic., and a copy of the manual. Send an email for pix. Please reply off
>> reflector. $450 here in central FL 33823. Phone 603-0369-2308 73 de Dave,
>> K1OPQ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|