Thanks, Carl, for mentioning that....
But how do you adjust the baud rate? The TT manual in Chapter 5 says software
"must be configured for a baud rate of 1200". Did you write a secret method and
not tell TT? :)
Whilst on the subject, there's a constant ticking of about 1 second when I use
the Paragon II in a data mode. It comes from the speaker. Any way to stop this?
Thanks!
Pete
WB2QLL
-----Original Message-----
>From: Carl Moreschi <n4py3@earthlink.net>
>Sent: Nov 15, 2020 1:25 PM
>To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>Subject: Re: [TenTec] Using N1MM with Paragon II
>
>The Paragon II uses an Icom interface. It's CIV address is 2C.
>
>The baud rate is adjustable but it must match what you select in N1MM.
>
>
>
>Carl Moreschi N4PY
>127 River Moss Way
>Hertford, NC 27944
>www.n4py.com
>
>On 11/15/2020 12:57 PM, Mike Golini wrote:
>> Has anyone controlled their Paragon (I or II) with N1MM?
>>
>> Any tips or tricks?
>>
>> Sent from my iPhone
>> Michael J. Golini
>> K1SLT
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|