| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Using N1MM with Paragon II |
| From: | Carl Moreschi <n4py3@earthlink.net> |
| Reply-to: | n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 15 Nov 2020 14:25:24 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
The Paragon II uses an Icom interface. It's CIV address is 2C. The baud rate is adjustable but it must match what you select in N1MM. Carl Moreschi N4PY 127 River Moss Way Hertford, NC 27944 www.n4py.com On 11/15/2020 12:57 PM, Mike Golini wrote: Has anyone controlled their Paragon (I or II) with N1MM? Any tips or tricks? Sent from my iPhone Michael J. Golini K1SLT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Need final RF transistors for Ten Tec Pegasus Model 550, Karl Heimbach |
|---|---|
| Next by Date: | Re: [TenTec] Using N1MM with Paragon II, Pete Ferrand |
| Previous by Thread: | [TenTec] Using N1MM with Paragon II, Mike Golini |
| Next by Thread: | Re: [TenTec] Using N1MM with Paragon II, Pete Ferrand |
| Indexes: | [Date] [Thread] [Top] [All Lists] |