Looks like 70-80W on 10m. The radio thinks it's a full 100W.
If I go down from 10m power goes up slightly, never quite 100W but close enough
for me.
Shawn kb1ckt
On Thursday, March 24, 2022, 10:18:17 AM EDT, Bob DeVarney W1ICW
<w1icw@myfairpoint.net> wrote:
Hi Shawn,
what's the output like on the bands 20 and above? I recently restored
one and spent quite a bit of time chasing my tail. I had full output on
160-40 but it dropped off rapidly above that.
I eventually discovered one of the final transistors was open. The
little "3D structure" of resistors/caps they used to bias the
transistors had a bad solder joint that had opened up and this killed
the transistor.
Take the final section off and give it a good visual inspection, and
maybe even wiggle things a bit in that area and you may find the same thing.
On 3/24/2022 9:04 AM, Shawn Upton via TenTec wrote:
So I picked one up last weekend, supposedly gone through and all that. Seems to be true, as it's seemingly
working--except for the drive? If I set ALC full clockwise, in order to get 80-90W out on 40m I have drive
set to 7.5. Seems high? I have an Omni C that is on the desk I'm comparing to. I'm not concerned
a bit about "only" getting 80W, I just want to make sure that drive needs to be this high.
Quick check shows 90W on 160m with drive at 7.75, while on 10m I get like 70W at 8.1 on the
knob. So it's actually really flat response on the drive--maybe I'm just too used to my Omni
where drive changes "a lot" from band to band. :)
Shawn kb1ckt
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec