So I picked one up last weekend, supposedly gone through and all that. Seems
to be true, as it's seemingly working--except for the drive? If I set ALC full
clockwise, in order to get 80-90W out on 40m I have drive set to 7.5. Seems
high? I have an Omni C that is on the desk I'm comparing to. I'm not
concerned a bit about "only" getting 80W, I just want to make sure that drive
needs to be this high.
Quick check shows 90W on 160m with drive at 7.75, while on 10m I get like 70W
at 8.1 on the knob. So it's actually really flat response on the drive--maybe
I'm just too used to my Omni where drive changes "a lot" from band to band. :)
Shawn kb1ckt
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|