K8GG wrote:
>To Broadband a shuntfeed, try paralleling two shunt feed wires.
>I believe Gary Breed, K9AY, wrote something about this a few years ago in
>the Low Band Monitor, edited by Lance Johnson.
Actually, DeMaw did it first in October 1975 QST titled Another Method of
Shunt feeding your tower He used four wires held together by 4" circuit
board squares.
The arm is 43" long and the 47' top loaded tower is tapped 26' from the
base. There is a 1,000 pF cap in series with the feed line. To tune the
capacative reactance, DeMaw used a top loading wire. I can attest to you
that a coil at the base is a much easier way to tune the antenna!
I have been using this scheme for years and it gives me a fairly broad
response across the band. The only difference is I feed my antenna at the
top in a unipole design.
Another good source of shunt feeding information is the series starting in
May 1975 Ham Radio Magazine by True.
73 Craig Clark W1JCC
Radio Bookstore & Radioware
PO Box 209
47 Fitzgerald Rd
Rindge NH 03461
Orders: 800 457 7373 - 603 899 6957
10am- 6pm EST
Fax: 603 899 6826
24 hours, 7 days per week
email: nx1g@top.monad.net
radware@radio-ware.com
sites: http://www.radio-ware.com
http://www.radiobooks.com
--
FAQ on WWW: http://www.contesting.com/FAQ/topband
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|