Topband
[Top] [All Lists]

Topband: Making low wires more visible de K0FF

To: <topband@contesting.com>
Subject: Topband: Making low wires more visible de K0FF
From: k6se@juno.com (k6se@juno.com)
Date: Fri, 8 Sep 2000 19:53:29 -0700
Tom, W8JI wrote:

Re: Beverages:
"Another cure is to not slope the ends, and bring them down along a thick
obstacle.  Six or ten feet of vertical drop is six or ten feet of drop,
whether in one small area or a 60 foot length. The response to vertically
polarized noise or signals is essentially the same, it just moves out
from the feedpoint a bit."
----------
That sounds reasonable, so I'll agree.
==========

"If you doubt that, consider the Pennant antenna. It works because the
pointed end acts like a second vertical, that picks up the same signal
level as the totally vertical wire at the other end. If it didn't, the
antenna would have only high angle horizontal component."
----------
I'm sure what Tom meant here is not that the pointed end of the Pennant
acts like a second vertical, but that the sloping top & bottom wires act
like a second vertical,  with their vertical components combining and
their horizontal components cancelling - at least this is how the model
shows it.

73, de Earl, K6SE


--
FAQ on WWW:               http://www.contesting.com/FAQ/topband
Submissions:              topband@contesting.com
Administrative requests:  topband-REQUEST@contesting.com
Problems:                 owner-topband@contesting.com


<Prev in Thread] Current Thread [Next in Thread>