Hi all;
While adjusting some topband RX antennas over the weekend, I noticed my 259B
analyzer was showing a slight problem.
It seems as though when it is powered up, the SWR meter needle swings fully
to the R/H side and then stops about 1/8" past the set mark. I found a page
on tower talk about the MFJ249/259 calibration procedures but it is totally
different from the 259B.
Can anyone help with calibration procedures and schematic diagram for same
259B. Thanks
Dennis KØCKD
Skills Unlimited
Dennis G. Peterson
1815 Mulberry Avenue
Muscatine, Iowa 52761
563 263 2272
|