In order to get a good TX CW bandwith in my home made TRX, I let the keyed
CW signal pass through the normally RX high quality crystal filter with next
stages of the transmitting chain being linear (linearity adequate for SSB).
It was moreless 20 years ago...
Who will be the first commercial provider of a TRX using this technique? I
give this advice for free!
73, Mirek
sp5ena@idea.net.pl
----- Original Message -----
From: <k6se@juno.com>
To: <elecraft@mailman.qth.net>; <topband@contesting.com>;
<1000mp@mailman.qth.net>
Sent: Monday, May 05, 2003 5:32 AM
Subject: Topband: Key Clicks
> I just finished measuring the CW bandwidth of my Elecraft K2 using the
> exact same test setup as when I measured the CW bandwidth of my Yaesu
> FT-1000MP.
>
....
|