| To: | <topband@contesting.com> |
|---|---|
| Subject: | Topband: Radial Plate |
| From: | "Dick" <dmcnutt3@cox.net> |
| Date: | Sat, 23 Aug 2003 16:37:45 -0400 |
| List-post: | <mailto:topband@contesting.com> |
Who makes a good radial plate...I have found one that is made of aluminum but concerned about dissimilar metal corrosion over time...probably brass would be best...or stainless steel...any ideas... Dick W4NTG.... _______________________________________________ Topband mailing list Topband@contesting.com http://lists.contesting.com/mailman/listinfo/topband |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Topband: Re: Low Topband Dipole/Propagation Outlook, Thomas Giella KN4LF |
|---|---|
| Next by Date: | Re: Topband: Radial Plate, Thomas Giella KN4LF |
| Previous by Thread: | Topband: PLF-2, Dick Wolf |
| Next by Thread: | Re: Topband: Radial Plate, Thomas Giella KN4LF |
| Indexes: | [Date] [Thread] [Top] [All Lists] |