Topband
[Top] [All Lists]

Topband: End Fed Twin Lead Marconi Antenna

To: topband@contesting.com
Subject: Topband: End Fed Twin Lead Marconi Antenna
From: Garry <g.drummond@verizon.net>
Date: Mon, 03 Mar 2008 22:52:59 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Hello,

I was wondering if anyone has had any experience with a Twin Lead 
Marconi using 300 twin lead as described in Bill Orr's "Wire Antennas" 
book. For the low end of 160 meters, it uses a twin lead length of 109' 
with both leads tied together at the far end and a 17' length of single 
conductor wire attached at this junction with the opposite end connected 
to an insulator used to support the horizontal portion at the far end. 
At the feed line end, one conductor of the twin lead connects to the 
center conductor of coax and the other conductor connects to ground and 
the radial system.

Orr states this antenna has an impedance close to 50 ohms and should 
match coax without the need of a tuner. I have tried building this and 
cannot obtain a 50 ohm match and have a lot of reactance using Orr's 
measurements.

Thanks,
Garry - WR4R

_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband

<Prev in Thread] Current Thread [Next in Thread>