Ed, Everything depends on the size and type of tower supporting the
wire plus of course the ground system you have in place. Some reports
are that the support structure, if it is metal, is merely excited with
RF and with the feed wire and the tower does much of the radiating.
There has been a wide range of reports of failures and successes i have
read over the years. Maybe some modeling of this design from a wooden
pole or tree vs. a steel tower with a beam on top would be nice to see.
IMHO a shunt fed tower with a cage feed and top loaded with some beam(s)
is the way to go.
Herb, KV4FZ
On 11/19/2011 1:42 PM, navydude1962@yahoo.com wrote:
> Has anybody tried one of these on 160m? Thoughts appreciated.
>
> 73
> Ed NI6S
>
> Sent from my iPhone
>
> On Nov 19, 2011, at 9:39, "Price Smith"<w0rihps@sbcglobal.net> wrote:
>
>> not conduct well. If it is not possible to drive a rod all the way in, avoid
>>
>> leaving a large amount above the ground. (Short metal lengths can pick up
>> signals like AM car radio antennas did years ago)
>>
>>
>> Carl and all,
>>
>> For safety reasons ground rods should NOT stick out of the ground. If one
>> would fall on one it would do some serious damage.
>> I dig a hole about 1 foot deep and drive the rod to below ground level. They
>> go in easy in most soils with a large impact hammer.
>>
>> 73 Price W0RI
>>
>> _______________________________________________
>> UR RST IS ... ... ..9 QSB QSB - hw? BK
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|