To: | <topband@contesting.com> |
---|---|
Subject: | Re: Topband: Choke Construction Info Needed |
From: | "Tom W8JI" <w8ji@w8ji.com> |
Reply-to: | Tom W8JI <w8ji@w8ji.com> |
Date: | Thu, 26 Jul 2012 18:12:32 -0400 |
List-post: | <topband@contesting.com">mailto:topband@contesting.com> |
70 turns 2" diameter over 4" length would be 100 uH, and with an air core and #16 magnet wire would have a Q of about 200 or so. That's 1000 ohms impedance, a few hundred thousand ohms parallel resistance, and the dissipation would be less than 1 watt at 1500. Or 38 turns over 4 inches on a 4 inch form. You could use #12 wire Teflon insulated, and have a Q of maybe 300 or so. Again less than 1 watt heat out of 1500. Personally, I'd use #12 or 14 Teflon on some old PVC pipe. 73 Tom _______________________________________________ UR RST IS ... ... ..9 QSB QSB - hw? BK |
Previous by Date: | Re: Topband: Choke Construction Info Needed, Tom W8JI |
---|---|
Next by Date: | Re: Topband: Choke Construction Info Needed, Tom W8JI |
Previous by Thread: | Re: Topband: Choke Construction Info Needed, Tom W8JI |
Next by Thread: | Re: Topband: Choke Construction Info Needed, Tom W8JI |
Indexes: | [Date] [Thread] [Top] [All Lists] |