Great - I appreciate you revisiting the article....I am going to try it in a
week or so. Jim R.
> From: w8ji@w8ji.com
> To: rodenkirch_llc@msn.com; topband@contesting.com
> Date: Tue, 2 Oct 2012 14:52:59 -0400
> Subject: Re: Topband: K6STI low noise receive loop
>
> Well, there is no "modeling" associated with this effort, Tom - they just
> "did it".....built it, tuned it and used it! I've attached the article for
> perusal, if interested....Jim R.
> >>
>
> I saw the original article. This one uses an isolated primary secondary
> coupling system.
>
> Try it and see if it works reliably in your installation. I think with a
> good layout and feedline routing you should be OK with this method.
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|