I have a hypoth--er hipoth--oh, alright, a theory, question for all. Take
a grounded, 1/4 wave vertical (pick your band/freq of interest) made of
tower sections. You're going to feed it with a gamma match. Could the
gamma match rod go on the inside of the tower sections for protection??
And, yes, I know, you could insulate the tower from ground and series feed
it. BUT, after all this is a hypoth....er hipoth....theory question.
Jake,
If the tower was a solid cylinder, you would be feeding it on the inside.
The walls would isolate the current inside from the outside; it would not
radiate any practical amount at all. It would be just like loading putting a
pin through a piece of coax to short the center to the shield inside the
cable and thinking we were gamma matching the outside of the coax shield.
Since the tower is a less-than-perfect cylinder (or coaxial line), the
system would radiate some small amount when gamma matched on the inside. The
amount of outside current would depend on how imperfectly it behaved as a
cage or cylinder.
I remember taking the time to learn why this happened when I tried to use
the fall arrest safety line of a large tower (it had a ladder on the inside)
as a way to shunt feed the tower. It was the deadest 350-foot tall antenna
imaginable!!
Also, some engineer at Phelps Dodge suggested I mount a repeater antenna
inside a wide face tower, to get a nearly omni pattern. I took his advice.
You can imagine how well that worked out!!
73 Tom
_______________________________________________
Topband reflector - topband@contesting.com
|