Topband
[Top] [All Lists]

Re: Topband: NEW BEV DESIGN?

To: topband@contesting.com
Subject: Re: Topband: NEW BEV DESIGN?
From: Jim Forsyth <jim@af6o.com>
Date: Wed, 15 May 2013 09:04:09 -0700
List-post: <topband@contesting.com">mailto:topband@contesting.com>
It is two wires, its RG6 coax (instead of ladder line).

Jim, AF6O


On 5/15/2013 8:21 AM, Mike Greenway wrote:
There is new player on the low band receive antenna market that will be at 
Dayton.  Here is the link

http://www.pixelsatradio.com/uploads/BevPro-1-Information-for-Web-site1.pdf

I have looked at their brochure but have one big question.  They say the feed 
point, which has two coaxes, can be put at any point on the wire.  If I put the 
feed point at one exteme end, that gives me a bi directional receive antenna 
with one wire?  I have used two wire systems and understand the need for the 
second wire there, but not sure I see the theory behind two directions from one 
wire fed on one extreme end.  I have seen designs that do feed at different 
points along the line and could see if the feed was put near center you could 
get two directions, but it would seem the closer to get the feed to one end, 
one direction is going to suffer due to shorter wire length.   I understand 
they will be at booth BA 0488 on Saturday.  See some of you at the Topband 
dinner on Friday night.  73 Mike K4PI


All good topband ops know how to put up a beverage at night.
_________________
Topband Reflector



All good topband ops know how to put up a beverage at night.
_________________
Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>