On 5/18/2013 10:35 AM, Charlie Cunningham wrote:
If you get the larger beads/tubes thatwill fit over RG-213 etc. you can make
excellent 1:1 current baluns by slipping them over the cable before putting the
connector on.
These are not "excellent" 1:1 current baluns below about 75 MHz. Below
that range, they are a lousy common mode choke, because they are
inductive. Inductive chokes resonate with a line that is capacitive, so
they actually increase the current. A line shorter than a quarter wave
is capacitive; so is a line between a half wave and 3/4 wave. And so on.
That's why we want a choke that is highly resistive -- the resistive
component always reduces common mode current, which is the objective of
a common mode choke (the so-called "current balun.")
There's an extensive discussion of this in my RFI tutorial, and also in
the Coax Chokes power point (which is a pdf). On my website.
k9yc.com/publish.htm
73, Jim K9YC
All good topband ops know how to put up a beverage at night.
_________________
Topband Reflector
|