Sorry - didn't make it crystal clear that this is a Delta shaped variant of a
EWE antenna!!!!
My bad for not utilizing all of the necessary verbiage to make that
clear....you see it in ON4UN's latest book on page 7-104.
> From: magoo@isp.ca
> To: rodenkirch_llc@msn.com
> Subject: Re: Topband: best core material?
> Date: Mon, 5 Aug 2013 14:00:48 -0400
>
> A full-wave delta loop would have the transformation done with a 1/4 wave
> line of 75 ohm cable. This must be something other than a full-wave loop?
>
> Bill VE3NH
> ----- Original Message -----
> From: "James Rodenkirch" <rodenkirch_llc@msn.com>
> To: <topband@contesting.com>
> Sent: Monday, August 05, 2013 1:33 PM
> Subject: Topband: best core material?
>
>
> >
> > I have a schematic for a delta shaped loop that shows I'll need an 18:1
> > transformer to transform the 950 ohms of the antenna to 50 ohms (feeding
> > it with 50 ohm coax).
> >
> > One transformer diagram shows an FT-140-43 core being used.
> >
> > BUT, looking over some of Tom's, W8JI, write-ups, I see where he uses 73
> > material instead.
> >
> > I see where 77 material replaced 73 material so -- is an FT-140-77 the mo
> > betta way to go?
> >
> >
> > Thanks, in advance, for any advice/info. Jim Rodenkirch K9JWV
> >
> >
> >
> > _________________
> > Topband Reflector
> >
> >
> > -----
> > No virus found in this message.
> > Checked by AVG - www.avg.com
> > Version: 2013.0.3392 / Virus Database: 3209/6552 - Release Date: 08/05/13
> >
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2013.0.3392 / Virus Database: 3209/6552 - Release Date: 08/05/13
>
_________________
Topband Reflector
|