Where is a selectivity spec or a description??
73 Tom
Tom,
Apart from the N2PK analyzer, I don't know any published selectivity spec.
The detector minimum res. bandwidth of the N2PK unit is 7 Hz and produces
+4dBm into 50 ohms.
FWIW, RigExpert put together a comparison of analyzers based on measurement
topology. For sure, it's a biased piece -- especially when the MFJ product
is discussed. So, keep that in mind.
http://www.rigexpert.com/index?s=articles&f=aas
The plot below shows how well the N2PK analyzer can selectivly ignore a
large multi-volt base voltage from three nearby AMBC stations located 2
miles to the south. Two of the AM stations are Non-D in the daytime. One
is 15KW, the other is 5KW. Note that the T is resonated to 1420 kHz, right
where the stations transmit (look for 1320, 1460, and 1530 kHz). The
attached plot shows total RF immunity on the X trace. On the R trace, small
"blips" do show - each representing the local AMBC stations. However, even
these can be easily ime-averaged away in the software.
http://72.52.250.47/images/N4NN.jpg
Paul, W9AC
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|
