Hi Mark -
I have not experienced K3 TX/RX antenna isolation problems with my station
configuration. I expect that if there is an isolation problem with your
rig's TX and external RX antenna routing/switching, that problem would be
nearly impossible to quantify using your station's TX and RX antennas. The
rig's TX/RX isolation would need to be measured on the bench, using good
laboratory grade equipment.
Perhaps, Elecraft can provide a list of expected isolation values that were
measured for each of the TX and external RX antenna routing/switching
configurations possible with the K3 and K3S. Those measurements would
surely have been done during the rigs' design performance verification
tests.
GL
73,
Terry K4RX
++++++++++++++
Hi Bill,
I think this is not what I meant here; I also do use BPF's and the Front End
Savers.
The problem is that while listening to your receiving antennas, there is
also some signal from the transmit antenna getting through thanks to the
internal cross-talk of your rig's TX/RX relay.
I was wondering what people do besides the obvious 'kill the TX antenna
input during RX mode' ?
73 Mark, PA5MW
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|