I use a Rohn 45G 100 ft tower. It is shunt fed for 160 with an Omega
match using two 1000 pfd vacuum variables. It does wrk great on 160
using around 50 radials. One of the vacuum variables has a 1 rpm 12 VDC
reversible motor. The SWR stays very low.
The monoband stack for 80 - 10 provides a lot of top loading..
I don't think you will go wrong Ron...
73,
Joihn, W4NU
(K4JAG 1959 to 1998)
On 8/18/2020 2:06 PM, Ron WV4P wrote:
Howdy All,
I'm getting ready to put up a Rohn 25 Insulated Base ~1/4 wave vertical.
(115') and I'd like to get some advice if possible.
I'm using guy brackets. Any reason to use Insulators between the Big Grips
/ Phillystran and the brackets like is recommended on higher bands ?
Any preferred goo or concoction to put on the tower sections before joining
them ? Or nothing ?
Any other advice on the tower / radiator itself from folks that have BTDT ?
My plan is 115' and I'm using a Rocket Top at the top. Without any mast I
will have my 115' but I plan to insert a mast into the rocket top (8') and
have it Inside the tower, not extended above the top. I figure if it
resonates too high I have 8' to play with up top.
Thanks, Ron, WV4P
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|