At C6AGU I have in-band RX on all bands. The rigs are Flex 6000 SDR-s. On
160 m I can hear virtually unimpaired to about 12 kHz off the TX frequency.
RX antenna is 4 direction delta loop, about 1000' from the TX vertical. The
RX path includes a high performance RX pre-amp. (The RX antenna "gain" is
-32 dBi.)
SDR-s can work for in-band RX, but you must have a very "clean" RX (and TX)
paths and plenty of antenna separation. Also, lots of shielding and
grounding.
73,
George,
AA7JV/C6AGU
On Thu, 20 Aug 2020 15:17:29 -0700
"Richard (Rick) Karlquist" <richard@karlquist.com> wrote:
On 8/19/2020 10:28 PM, donovanf@erols.com wrote:
Hi Ron,
700-1200 foot spacing should provide good in-band receiving capability.
SDR receivers won't work for in-band receive, you must use a traditional
transceiver such as the K3, K4HD, FTdx5000, IC-7800 etc.
Micro-arcing is caused by transmitted RF jumping a spark gap.
Any metal-to-metal joint that isn't securely bonded is a candidate
for micro-arcing.
73
Frank
W3LPL
Three questions:
1. Does "in-band receiving" mean the same thing as SO2R in a single
band contest? I operated a few 160 meter contests in that mode around
10 years ago. I used a carefully nulled receiving loop 1000 ft from the
TX vertical.
2. Please explain the comment about SDR receivers not working. I
now have a Flex 6700 that claims to be able to do full duplex. And
that radio would not work?
3. If connections between R25 sections cannot be trusted, then
how would any crank up tower possibly work as a vertical? I have
always wondered about this.
BTW, cellular sites have significant problems with what they
call "passive IMD", of which micro-arcing is a subset.
73
Rick N6RK
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|