Sounds like you are still unsure, and that is a guess. You said the swr
is 1.4:1 , I guess this what the SPE shows with SPE in standby, and txcr
keyed ?
If so when switched to operate, you should be able to gradually increase
drive power form a very low level and raise until you see the output power
level where SPE indicated swr suddenly increases and trips the amp? Or
is the alarm instant regardless low low drive is in low power profile.
Test in FT8 in ssb is one good way to go from 0 output & up using audio
level adjustment modulating the drive.
The SPE can be controlled from a few watts output smoothly through to
the point where issues occur.
If the swr holds good until a output power level point where it fails,
then it provides more clues to the problem.
An instant swr trip to standby regardless of drive level however low or
0, is another issue.
vk4tux
On 30/10/21 09:54, WW3S wrote:
With the help of #1 son, during a lull in the monsoons, we isolated it to my
KK1L 2x6 box, mounted on the outside of the house. Sounds like maybe some
relays clicking and clacking, probably rfi coming thru the control cables,
despite clamp on toroids everywhere and the cables wrapped numerous times thru
double ferrite cores. I do have a couple of unused ports, I wonder if it will
help if I terminate those with dummy loads?
Sent from my iPad
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|