Get a block of aluminum about 2.25" square... have a local machine shop drill
two holes through it.. one hole to be the right size to clamp to the leg of
the tower (or ground rod as the case may be) and the other to clamp to the
hard line (sans jacket).. then they can saw half blocks out of this to form
clamps, add 3/16" clamp bolt holes, and you are in business...
I get my aluminum from:
Dillsburg Aeroplane Works
Dillsburg, Pa
717/432-4589
Cheers ... Denny k8do@aol.com
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|