Towertalk
[Top] [All Lists]

Source for rotor disconnect plugs

To: <towertalk@contesting.com>
Subject: Source for rotor disconnect plugs
From: robrk@fyi.net (Bob Morris)
Date: Tue, 12 Nov 1996 11:05:16 -0800
Craig Clark wrote:
> 
> At 10:06 PM 11/11/96 +0000, you wrote:
> >I am looking for a source for disconnect plugs for a rotor cable and
> >for a switch box cable. I need to handle 8 wires in the switch box.
> >
> >I see the Wireman carries a product called Powerpole that can be
> >configured for up to 8 wires. I have not yet looked in the auto
> >stores for "trailer light" type connectors.
> >
> >Any recommendations from those who have tried a connector type?
> >
> My disconnects are inside. I used Cinch-Jones connectors I have had in my
> junk box for years. They come in all numbers of connections. I color code
> them too to keep from misconnecting cables.  If you want water proof
> military surplus or marine service (VERY expensive) will work too.
> 
> 73 Craig
> 
>                         Craig Clark
>                      soon to be ex-NX1G
>         send me e-mail and I'll put you on our mailing list
>                         Radio Bookstore
>         Books for Amateur Radio, SWL and CB Radio Operators
>                         (603) 899 6957
>                         (603) 899 6826 fax
>                         PO Box 209
>                         Rindge, NH 03461
> 
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 K7LXC@contesting.com
> Sponsored by Akorn Access, Inc & KM9P

Radio Shack "Molex" plugs and sockets work fine...I used solder
on the pins, just for fun.... K2RK

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>