In a message dated 96-12-06 13:33:16 EST, you write:
> I thought that Rohn 6 was the stuff lacking diagonal bracing. I
>believe Rohn 20 has diagonal bracing like Rohn 25, just fewer per section.
Randy --
Thanks for your correction and I believe you are correct. I've seen
some 20G and it is different enough from 25G to give it a different part
number.
I have no information on the diagonal-less Rohn 6 other than I've seen
miles of it in the midwest that was installed for TV antennas in the
pre-cable days. Anyone have any factory info?
Nonetheless, conservative engineering and installation is ALWAYS
recommended - especially if you're not sure.
73, Steve K7LXC
TOWER TECH -- professional tower supplies and services for amateurs
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|