At 01:52 AM 12/19/96 -0500, Jon Zaimes AA1K said:
>My AS45 plate basically looks like it is the size of the AS25 plate, but
>instead of the bent flanges at the corner of the plate as in the AS25, the
>AS45 uses a piece of angle iron at each corner, welded to the plate. Holes
>for the U-bolts to fasten to the tower are drilled in the angle iron.
You know, all of this is very helpful, but when I look at stuff like the
above,
I sure do wish that there was just a book, WITH ILLUSTRATIONS, that
showed what most of you guys are talking about.
Has anyone written a good book on practical ham tower installations?
||Larry||
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Studio - D Productions http://www.bright.net/~larryd/
"Very few people can afford to be poor."
G. B. Shaw (1856-1950)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|