Towertalk
[Top] [All Lists]

[TowerTalk] Switching 450 ohm twinlead?

To: <towertalk@contesting.com>
Subject: [TowerTalk] Switching 450 ohm twinlead?
From: mainhart@juno.com (Rick Mainhart)
Date: Fri, 06 Jun 1997 18:30:23 EDT
On Fri, 6 Jun 1997 10:53:23 PST henrypol2@juno.com (Henry A Pollock)
writes:
>Re all the recent posts about the RCS8V coax switch.  How is the best 
>way to remotely switch 450 ohm twinlead? 

For the ultimate in power handling capabilities, I'd go with three-phase
contactors (sometimes called starters). These puppies come in many
flavors and sizes, but unless you're into hot-switching (which I wouldn't
do), you don't need the arc-quenching 550 amp versions.

Coil voltages range from 12 to 480 Volts ... and auxiliary contacts to
prevent keying into an open.

Prices vary depending on the source, but for a 7.5 kW unit figure on
$50-75.

As for impedance bumps at 450 ohms ... I don't think I'd worry much about
that. Same thing with putting everything into a non-conductive box ...
probably more expense than required.

If the price is too high, look for starter relays and/or auxiliary
lighting relays at your local automotive parts house. Calculate your
maximum current, and provide a bit of margin.

73,

Rick, WB3EXR


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>