From:
Fred Hopengarten K1VR 617/259-0088
Six Willarch Road
Lincoln, MA 01773-5105
permanent e-mail address: fhopengarten@mba1972.hbs.edu
On Mon, 18 Aug 1997 09:23:35 -0500 "Effinger SH (Sam) at MSXSOPC"
<SE060676@shellus.com> writes:
>diagrams just wondering who else has wired them if any pit falls to
>avoid...
1. Don't allow coax coming out of a connector to make a sharp bend.
Something will eventually fail.
2. Don't put a BNC with a UHF and then coax without supporting the coax
somehow to avoid breaking something in the adaptor stage. This is a
purely mechanical problem.
3. Label coax lines. Some people use colored tapes. Some use nail
polish colors. You don't want to trace out lines by following one by
hand during the middle of a contest while lacking sleep.
4. Make or buy all lines the same length so that they are substitutable.
Do not make custom lengths for each band or rig. In other words: Make
them all 3' or all 5' or all 10', whatever. If you ever split rigs apart
to do a multi-single, instead of SO2R, you'll also want to use additional
jumpers all the same lengths.
5. Make or buy spares. Easier now than at 9 am during the EU "rush."
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|