Pete,
If each of your connectors actually have .6 dB loss, they should be
getting red hot! Are they extremely hot when u use that antenna?
73
Frank
W3LPL
donovanf@sgate.com
On Thu, 30 Oct 1997 TOMK5RC@aol.com wrote:
> In a message dated 97-10-30 06:23:05 EST, n4zr@contesting.com writes:
>
> << For whatever it's worth, my run of approximately 250 feet of 3/4" CATV
> hardline measures (with an Autek RF-1) to have 1.6 dB of loss at 28 MHz -
> not nearly so good as the Handbook table says it should be (about .36
> dB/100 fit). Of course, this includes 2 home-brew UHF connectors. I've
> checked for moisture infiltration, etc., but this is about what the
> installation measured right off the reel. I wonder if others have
> compared measurements of their actual installation with the Handbook table
> -- I'd sure like to recoup that elusive "'nother dB."
>
> 73, Pete Smith N4ZR
> n4zr@contesting.com
> >>
> How much of the loss can be attributed to the connectors?
>
> Tom, K5RC/7
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|