Help!
I am enlightened by all the technical postings, but now I confess
the need for help:
David Robbins K1TTT said:
> it depends on your definitions. my stubs are 1/4 wave shorted
> at the frequency i want to pass.
L.B. Cebik W4RNL said:
> Easy way to remember which trap does what with 1/4 wl:
> the impedance at the connection end is opposite the impedance
> at the far end. Short = zero ohms, hence connection
> end = high Z--good for a series filter connection for the
> frequency to be nulled.
As there statements are difficult to reconcile, could someone
please give an account of a two transceiver station
where the run TX is on 14MHz and the multiplier TX is on 28MHz:
(a) What stubs/filters would you place between the 14MHz
transciever and the amp; or after the 14 MHz amplifier?
(b) What stubs/filters would you place between the 28MH
transciever and the amp; or after the 28 MHz amplifier?
Regards,
Martin ZL1ANJ
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|