In a message dated 98-02-19 23:59:20 EST, w7ni@teleport.com writes:
<< have the need to climb some trees in my backyard for some stealthy
>antennas. I'm wondering where I can get information on the needed
>supplies for climbing a tree? Seems like I'll need some spikes of some
>sort. >>
Bill,
Being a "pure stealth" antenna user, I have avoided climbing trees by instead
using a 24' painter's pole (available at Home Depot for $39.00). It is light
enough that I can hold it above my head with one hand and drop wires in trees
at the 30 + foot level. If I need to go any higher, I use a small ladder for
the extra height.
I attached a small hook at the tip of the pole, and use a heavy monofilament
fishing line with a weight attached as my leader line. I just drop the weight
over the desired tree limb, and let the line unroll.
I have never used an end insulator, either just the fishing line, which has
good dielectric properties, or some teflon line. I use #20 or above wire on
all antennas. Cheap plastic coat hangers can be cut to make an excellent
center insulator for an inverted vee. I simply "hang" it on a convenient
limb. I cut up the remaining plastic as spacers for my open wire feedlines.
I haven't climbed a tree yet, but have been able to get my antennas up into
the highest tree limbs available with minimal effort. This may be a better
alternative than getting a lot of expensive climbing equipment to hang fine
wires.
Most serious contesters would roll on the ground laughing if they saw the
antennas I use. However, Bill, I think you'll be amazed at what you can
accomplish with simple, stealthy wire arrays.
73, Paul, "Stealth Man", KB8N
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|