In a message dated 98-03-23 08:52:40 EST, sjb@fuse.net writes:
> need help identifying a tower I recently purchased. the tubular ends are
> 10.5" on center, so there are no mounting plates for cement that I can
> find for that size. I believe Rohn is about 11.5". This tower has large
> horiziontal braces, 5 per 10' section. No Z bracing. It does have a nice
> cone shaped top section. Any ideas?
This is a tower for TV antennas. It doesn't have much torsional
resistance or much load capacity. If you're real careful, you could probably
put a small tribander on it but I wouldn't push it very far. Be conservative
and you'll be okay.
Cheers, Steve K7LXC
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|