Never used this stuff before, so rather than messing up, figured I'd ask
the following:
1. I have end caps for the 6700 Phillystran cable - what is the best
thing to use to ensure they don't fall off?
2. All guys will have 1/4"EHS for the lower 30'. When applying tension
should I use the tension gauge on the 1/4"EHS section and set for the
EHS recommended 660# or what? I assume tension is tension, no matter
where I check it. This right?
TNX in advance for your input. 73, Terry,
--
Terry A. Cox - KB4KA - Collierville, TN
e-mail to tacox@concentric.net
webpage at http://www.concentric.net/~Tacox
KB4KA PacketCluster on 144.97 direct or via ROSE address 901002
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|