Dear John;
I put together over the years a 56 page (now 63 pages) of "ALL YOU NEED TO KNOW
ABOUT PROP PITCH ROTATORS". I'm sharing this with everyone but need $13.00
($3.00 covers US mail) to break even on the offer.
After you get the manuals and still need help, call me. I have been
refurbishing the small P/P units for many years....
Regards,
Joel, K2QBV
E MAIL> firstcall@cyburban.com
FIRST CALL COMMUNICATIONS,INC
(a direct distributor for US TOWER CORPORATION)
K2SIG wrote:
> Good morning Folks,
> I found a prop pitch in the dungeon and I wonder if you folks could
> help me out to the point of
> finding out what it is and what voltage/amps are needed to test it.
> 1. Cover missing and there are four wires showing betwix motor and
> gear box, one at 0 degrees,two at 90 degrees and one at
> 180 degrees .
> 2.There is a plate partially rusted that indicates a gear ratio of
> 9556:1,but reall not sure of the 55 betwix the 9 and 6.
> 3.radially there are two grease fittings and one plug around the gear
> box.
> 4.the output shaft is a pipe about 10"long, 2.875" dia. with a ring
> gear welded to it next to the gear assembly.
> 5.There are partial remains of a sticker attached to the gearbox that
> say something about "RIGHT HAND"
> 6. It probably weighs about 40 pounds, and mostlikely was modified
> for amateur service.
> All I want to do is see if it runs.
> Thanks folks/73
> John k2SIG@empireone.net
>
> --
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|