A simple fix I have used is to put a dab or two of Dow Corning type silicon
on the bolt (and nut, if is not a threaded-in connection like the base of a
rotor). I would not recommend to glob up these points, just a dab/two to
keep them from moving and it will clean off well enough.
Mike R3/K5UO
Moscow
>>
>>
>>
>>>The four bolts that hold the two halves of one of my Ham-4
>>>Rotors have loosened up. In fact one of them has fallen
>>>out and I can't find it. Has anybody tried Loctite
>>>Blue on these? Anything special about these bolts other
>>>than the fact that they are Taptite 12-24x 3/4"? I guess
>>>Taptite means that they come with the captive lockwasher?
>>>I was thinking of looking for some locally to speed up the
>>>repair job. Thanks.
>>>
>>>Dave Hachadorian, K6LL
>>>Yuma, AZ
>>>K6LL@juno.com
>>>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|