......on the last of the three 204BA's rebuilt over the past two years I
used a couple of products I mentioned once here before on Towertalk....a 3M
product that chucks in your VSR electric drill is a series of pieces of
sandpaper the flap up against the work - this worked very well sans
solvents...and for the other half of the connection I found that a plumbers
fitting brush worked great - it is a wire brush that is round and comes in
all kinds of sizes, I bought about 10 sizes from 1/2" up to 2" for my tool
box for about twenty bucks...wished I had found these toys before the
project began!
73,
Jim, K4OJ
k4oj@ij.net
Proud member of the Florida Contest Group - visit our website at:
http://www.4w.com/deemer/fcg.htm
The Florida Contest Group sponsors the Florida QSO Party, check out the FQP
website@:
http://home1.gte.net/wd4ahz/fcg/ssqp.htm
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|