Another question.
I have a Delta-4 coax switch with uhf connectors.
Antennas are a multiband yagi, 80 dipole and the 3rd connector is for
the dummy load.
That leaves 1 antenna position open.
Should an unused position/coax connector be covered with a termination
connector.
I know that cable coax distribution blocks should have termination caps
screwed onto unused ports.
Should the same precaution be taken with antenna switches?
How would you go about making a termination connector? Just short it
together?
------------------------------------------------------------
If you can't understand it, it is intuitively obvious.
------------------------------------------------------------
Bill H. in Chicagoland
w9ol@billnjudy.com FireBrick@telocity.com w9ol@telocity.com
|