In a message dated 5/1/01 8:42:23 PM Pacific Daylight Time, wx3k@ptd.net
writes:
> What is the recommended method to clean heliax cable connectors ? I have one
> connector that is tarnished compared to the other cables I have
Hmm...that's a new question. You only have to worry about the spots where
the connectors make electrical contact. How bad are they? What's the
material? I think most commercial Heliax connectors are brass. Are they
N-connectors or UHF (PL-259)? Actually unless they were REALLY in bad shape,
I wouldn't worry about it. The outer shield should be electrically and
mechanically connected by the threaded part of the connector so the threads
will make good electrical contact as you install it. You might want to touch
up the center conductor with a little abrasive but that's about it.
Cheers, Steve K7LXC
Tower Tech
List Sponsor: ChampionRadio.com - Trylon self-supporting towers,
safety equipment, rigging gear, LOOS tension guages & more!
http://www.championradio.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|