On Mon, Aug 20, 2001 at 07:48:02PM -0500, Jimmy Floyd wrote:
>
> Hello all;
> I have a 40 ft Rohn 25G tower with an A3S tribander at the 41 ft. level.
> There is 5 to 6 feet of 1 and 3/4 inch mast above the tribander. Plan is to
> install an Antron 99 cut for 10 meters above the tribander.
> Two questions:
> Is the 5 to 6 ft spacing enough to not allow interaction?
> If I leave the Antron uncut and use a tuner to also load it on 15 and 20
> will that cause a problem with the A3S?
Since it would be cross-polarized to the A3S, there should be minimal
interaction (assuming you don't add any radials). I also doubt that
the performance would be very good, compared to the A3S.
Bob, N7XY
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|