alex wrote:
> We are using two relays for the output stages. One relay for the output
> function and the other for the input function. This way you can tailor the
> relays individually for bets cost/performance tradeoffs. I recommend for the
> output function an OMRON G8J-1C6T-R-DC12. This is an sturdy automotive, fully
> encapsulated relay rated at 40ADC. We have tested it at 5KW/30MHz for
> 5 minutes and it did survive.
> For the input function I will recommend the G2RL-1-E. This relay could be
> replaced by more mundane one such the Magnecraft W7PCX which is very,very
> tiny :)
> You will thus need three relays . Two for input (one at the input, the
> other at the output) and an output relay. If you nag me enough I could draw
> a schematic for you :)
>
> Also, I will _STRONGLY_ advise to use a sequencer (one 10c IC , 4 resistor
> and 4 capacitors) with any complex relay system.
As long as you're going through all this trouble, why not simply buy a (used)
vacuum relay, add a reed-relay for the input, replace the bias circuit and make
the amp full QSK?
73 .......... Zoran WA7AA
AN Wireless Self Supporting Towers are now available! Windloading tables,
foundation diagrams and charts, along with full details are now at the
AN Wireless Web site: http://www.ANWireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|