share with us Toddles...on a related matter...
I am considering using some scrap pieces of what I think is Teflon
picked up at a flea market. I want to use them as horizontal thrust
bearings on a tall rotating mast...seems like these should be a good low
rpm choice...
The mast would be aluminum and these would have a hole in the "plastic"
slightly large than the mast...the stock is about a half inch thick and
in turn would be bolted to an aluminum plate with a slightly large hole
than is in the "plastic"...should take care of lateral movement it seems
and at the same time would not chafe the aluminum mast during rotation.
Is there a concern I should have for ability of Teflon (this might be
something else but lets assume is what the guy selling it said it was)
and its exposure to UV - a crucial problem here in FL.
Thanks-
Jim, K4OJ
Tod-Idaho wrote:
>
> I wonder if any reflector participants can suggest sources for sheet Teflon?
> Or sources for Teflon tube in diameters greater than 2.5 inches?
>
> Tod, KØTO
>
> _______________________________________________
> Self Supporting Towers, Wireless Weather Stations, see web site:
> http://www.mscomputer.com
> Call 888-333-9041 to place your order, mention you saw this ad and take an
> additional 5 percent off
> any weather station price.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
|