I had a new septic system installed a few years ago and the backhoe clipped
by 4" PVC conduit. Mine was broke all the way around, but the wires were
unharmed. I removed the jagged edges and cut another piece of PVC a little
longer than the gap. I then sliced it in half a and cemented it in
position. I also secured it with hose clamps.
----- Original Message -----
From: "Barry " <w2up@mindspring.com>
To: <towertalk@contesting.com>
Sent: Thursday, July 24, 2003 22:48
Subject: [TowerTalk] Repairing PVC?
Just noticed the wall of my 4 inch PVC cable conduit has a hole in
the side, possibly caused by a lawn mover. Is there some kind of
patch available for this (or other suggestions)? It's a ragged edge
hole about 2 inches across.
Tnx,
Barry--
Barry Kutner, W2UP Internet: w2up@mindspring.com
Newtown, PA Frankford Radio Club
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|