Does anyone have any information on the appropriate length of the Beta
bracket from driven element for a 205CA 20M monobander? The manual
shows 17 inches but the actual length of the beta rods is 30 inches. Is
it appropriate to move the bracket up to the 17 inch mark and leave the
remaining rod hanging out?
AG5TX
**********************************************************************
This e-mail is the property of Enron Corp. and/or its relevant affiliate and
may contain confidential and privileged material for the sole use of the
intended recipient (s). Any review, use, distribution or disclosure by others
is strictly prohibited. If you are not the intended recipient (or authorized to
receive for the recipient), please contact the sender or reply to Enron Corp.
at enron.messaging.administration@enron.com and delete all copies of the
message. This e-mail (and any attachments hereto) are not intended to be an
offer (or an acceptance) and do not create or evidence a binding and
enforceable contract between Enron Corp. (or any of its affiliates) and the
intended recipient or any other party, and may not be relied on by anyone as
the basis of a contract by estoppel or otherwise. Thank you.
**********************************************************************
|