Sorry to bother this list with my questions but it is antenna related and
the antenna is going on a tower so.....
Anyhow, this has already been posted to the Force12 reflector but that list
must be under full moderation as it is brutally slow in turn around and I
would like to get this beast together so I can start trying to figure out
how the heck I'm going to get it to the top of the tower!
What follows are two messages sent to the F12 reflector. Please read both
messages before responding as they are somewhat interleaved. Hopefully
between here and the F12 reflector I can sort this out but I'm getting a
little smoked at the manuals apparent discrepancies! Its not like this
product came out yesterday!
Thanks for any and all assistance and feel free to respond off list if you
feel this is not the appropriate place.
Mike / W8DN
*** Message #1 ***
> Hi All,
>
> Putting my C4SXL together and just ran into a problem. Suspect it is a
> missprint in the manual but not 100% sure.
>
> Anyhow, the manual says there is an extra hole for adjustment up or down
the
> band, This same note appears for the 10meter refl (#3) and the 10meter
> driver (#6). In addition there is a note on the C3S drawing which
correctly
> states there are holes which allow adjustment of + or - 2 holes for a
change
> of 250khz per hole on el #6. No mention is made of el #3 and, in fact, the
> three holes in the tip of #3 will align only one way! My guess is the
manual
> is wrong and there is no adjustment for the reflector. Can anyone confirm
> this? Worries me in that I would expect the manual to be nearly perfect
> after this much time!
>
> In the mean time I guess I will move on to another element. Thanks.
>
*** Message #2 ***
OK, I think it is definitely time to quit for the day - I'm REALLY confused
now! I put the 10m driver (#6) together and THOUGHT I counted 4 holes in
the tip of the element. The manual says there is an adjustment of +/- 2
holes so I left 2 holes exposed thinking this would move the resonant point
to 28.30 (28.800 - 2 x 250kHz). Now I'm putting the 15meter driver together
and I KNOW it has 4 holes in the tip of the element. As I am deciding where
I want to set it (125kHz per hole) I realize that 2 holes in the larger
element and 4 in the smaller part only gives me an adjustment of +/- one!
Hmmm. That is the same thing I had on the 10meter driver - wasn't it? Before
I drill the rivets on the 10m element to see if there are really 5 holes,
can someone tell me for sure how many holes are in the tip of the 10m driver
(#6)? If there are only 4, how the heck do I get +/- 2 holes of adjustment?
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|