Do I understand correctly....that the thrust bearing (a) takes the weight
off the rotor, and (b) allows removal of the rotor while leaving the mast
and antennas in place? Any other purpose(s)?
I have the good fortune to have a tiltover tower, so I can install
everything while it's horizontal, with no load on the mast. is 1/2" enough
of a gap to leave in the mast-to-rotor connection? Do I then just tighten
the thrust bearing set-screws as tight as I can? Or is there more to it? (My
thrust bearing didn't come with instructions, and I've never done this
before.)
Jerry K3BZ
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|