Plan to have a adapter made to slip over my Old Wilson rotatable crank up.
It has a solid rod that fits in a big bearing and the rotator sits at the
bottom and attaches to this rod/shaft.
The shaft measures 1.5" using a micrometer.
Obviously this is too small to center into the TailTwister.
As I don't have a manual but reading an old HamIV manual it says that 2
1/16OD mast would be perfect for centering in the clamps.
Is that the same for the TailTwister?
I'm planning on getting a adapter with an ID to slip over that Wilson shaft
and center into the base mounted Tailtwister.
How much bigger than the shaft should I make the ID of the adapter?
as always, please and thank you.
-----------------------------------------------------
If a family tree falls in the woods will anyone hear it?
-----------------------------------------------------
Bill H. in Chicagoland
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|